Post Description

Speciaal op verzoek deze HSPL voor de HTC Touch Pro 2[b/] 

ONCE YOU HAVE FLASHED A HARDSPL ITS PERMANENT. YOU DONT NEED TO DO IT AGAIN WHEN FLASHING NEW ROMS OR RADIOS*[b/]

*DO NOT start another process while the flashing process is taking place*
*DO NOT click off of the status bar... Let it stay in the foreground* 
*DO NOT let the Screensaver activate* 
Any of these can lead to a bad flash and possibly brick your phone

*FLASH HARDSPL BEFORE FLASHING ANY CUSTOM ROMS* 

1. YOUR DEVICE MUST HAVE AT LEAST 50% BATTERY POWER FIRST BEFORE ATTEMPTING EACH STAGE

2. FLASH HARDSPL

IMPORTANT: Each user gets 1 license, or perhaps 2-3 on request if needed (valid forever and works as transparently as possible, so it won't be a problem at all)
PM cmonex to request 1-2 more devices for private user (free).

NOTE1: This package is for Rhodium (Touch Pro 2, not the original Touch Pro) devices.[b/] CDMA-GSM worldphone version is not accepted (RHOD400, RHOD500 modelids), that will have its own HardSPL later. This HardSPL supports WM6.5

Flashing via ActiveSync with USB Lead (thanks to OliNex)
1. extract your HSPL to an empty folder
2. Synch Phone with PC in Windows Mobile!!! It has to be connected to activesync or WMDC via USB cable and it must not be in Flight/Airplane mode (i.e. radio should be on)
3. NEW: Internet access is required as the program checks online for updates and license
4. Run Rhodium-HardSPL_V2_00R3.exe on PC, make sure it's launched from a local drive (not through network drive, etc.). XP requires Admin logon and Vista/Windows 7 will automatically prompt to allow it to run in Admin mode, allow it. If you get an AntiVirus warning please ignore it, it contains no harmful code (just used a packer to compress it)
5. Follow steps as prompted in the HardSPL program. If this is the first run of HardSPL on a device after Hard Reset, you must select Automatic Flash Mode (first button in Welcome Screen) 
NOTE: You should usually go for Automatic Flash Mode. The Manual Flash option is only to be used as noted below and you must only attempt the Manual Mode option if Automatic Flash Mode or SSPL-Manual.exe already put device in black screen. Any other errors triggered while running in Autoflash Mode will have to be fixed as instructed in the error message.
6. It will ask you to wait while it prepares for the flashing, press OK
7. Now it should go through without any error messages, if one does pop up then follow the instructions included in the error text. If no specific instruction is shown then ask for help in the thread, but this should not ever occur (as this means a really fatal error occurred)
8. At this point the phone hopefully went to a black screen (reporting version as 1.01.C-SSPL only using "info 7" in mtty), this is the SSPL version, which is temporary. Then RUU will instantly launch
9. NOTE: When RUU says it will Hard Reset do not worry, it is not going to do that. Also when it says the flash will take 10 minutes ignore that, it will only take a minute or so
10. SPL flashes, device automatically reboots, job done

*Go into BootLoader Mode (do a Soft Reset while holding the "volume down" key on the left side of the device. Keep holding the "volume down" key until you see tricolour screen which is the bootloader mode, then release it) and verify the screen shows 0.85.OliNex, which is the HardSPL version*